Радиоуправляемые модели в Израиле

Радиоуправляемые модели в Израиле
Текущее время: 29-03, 09:06

Часовой пояс: UTC + 2 часа




Начать новую тему Ответить на тему  [ 1 сообщение ] 
Автор Сообщение
 Заголовок сообщения: Futaba10C 2.4Ghz
СообщениеДобавлено: 10-06, 23:25 
Не в сети
Модератор
Аватара пользователя

Зарегистрирован: 04-02, 00:24
Сообщения: 173
Откуда: Dead-Sea Kibutz Ein-Gedi
Futaba анонсировала новую линейку пультов основанных на технологии FAAST 2.4Ghz в которую входит Futaba10C 2.4Ghz.
Аппаратура прийдет в страну гдето к концу месяца.

Изображение
Немного о функционале Futaba10C 2.4Ghz :

The 2.4GHz system that offers the impossible: Pro-level features at a sport-system price.

Some people feel that a 2.4GHz system with a built-in module will always offer better response than a modular system. Nothing could be further from the truth.


The 10C is a modular system, yet offers response superior to most “dedicated” systems. Why? Because response doesn’t depend on whether your module is built-in or modular. It depends on whether your signal starts in analog or digital form.


Converting a signal from analog to digital form requires processing time — what you experience as lag. The 10C, on the other hand, was designed with a totally digital data stream. The signal starts digital and stays digital. Since no additional processing is needed, there’s no lag, either — just virtually instantaneous, real-time response.


And because the 10C is modular, you can use the TM-10 module to fly 2.4GHz-equipped aircraft…or replace it with a 50 or 72MHz module, and fly existing models without added equipment or expense.


Advanced Heli Menu

The 10C accepts separate gyro sensitivity, governor speed and servo travel rates for up to 4 flight modes — and automatically changes all three when the flight mode changes.
6 Programmable Mixes (4 linear/ (2) 5-point curves)

8 Factory-Defined Mixes: Hover-Throttle; Hover-Pitch; Throttle-Needle; Governor; Offset; Revo (5-pt.); Delay; and Throttle Mix (ail/ele/rdr)

Gyro menu
Plus
8 swash plate types w/graphics
Swash Plate AFR
(4) 7-point throttle curves and (5) (including throttle hold) 7-point pitch curves

Adjustable High/Low pitch setting

3 Adjustable Idle-up conditions



Advanced Airplane Menu

8 Programmable Mixes (4 linear/ (4) w/5-point curves)

9 Factory-Defined Mixes: Elevator-Flap; Ailvator (for dual elevator servos); Throttle-Needle; Aileron Differential; Flaperon; V-Tail; Elevon; Snap Roll; and Air Brake w/elevator delay
Dual/Triple rates (4 ch.)

Exponential (4 ch.)

Idle down

Throttle cut

Throttle delay

Throttle Hold & Idle-up w/delay
Plus

2 independent gyro settings

7-point throttle curve

Flap trim



Advanced Glider Menu

8 Programmable Mixes (4 linear/ (4) 5-point curves)

12 Factory-Defined Mixes: Butterfly-Elevator (2); Elevator-Flap; Chamber Mix (w/ail/ele/rdr adj.); Aileron-Flap; Aileron-Rudder; Flaperon; V-Tail; Flap Trim; Butterfly w/spoiler adj; and 4-point Offset (w/camber adj. for basic/launch/thermal/speed)
Plus
Adjustable spoiler

Adjustable Throttle Cut

Single/Dual Aileron and Flap Servo Selections

Start, Speed, Distance & Landing conditions, Adjustable Airbrake Activation

Adjustable Motor Cut






10C System Overview:

Big, 160 x 72 LCD with backlighting, adjustable contrast & auto-off

Dial ‘n Key™ programming w/joystick navigation

15-Model memory (expandable w/optional CamPACs)

10-character user name

10-character model name

2048 resolution in FASST 10-channel mode

Basic & Advanced menus

Enhanced airplane, heli & glider software

Smart Switch Technology™ (SST) — Logic Switches allow you to activate a function when specified switch and/or stick positions occur

Up/down on/off timer (activate by stick or switch)

Tracks service hours for radio and models

Mode 1-4 selectable (Modes 3 & 4 programmable)

Assignable functions/switches

Auxiliary channel screen — for 1-step function/switch assignment & eliminating unused auxiliary functions

2 proportional slider switches

Digital trims on all 4 main channels

Trim memory & sub-trims (all channels)

Adjustable trim steps (1-40)

Fail-safe, servo reversing & EPA
“Full Functionality” trainer system (cord required)

Flap switch (3-position)

Retract switch

Rotary Dial (3)

Adjustable Throttle Cut/Idle Down

Sticks w/length & tension adjustments

Servo cycle w/bar graph displays

Constant trim, voltage, name and timer display



И конечно же приемник на 14 каналов:

R6014FS Receiver


True, 14-channel design.

Designed specifically for FASST™ 2.4GHz systems.

Push-button Easy-Link™ feature locks receiver to the transmitter’s unique signal.

Includes battery fail-safe with auto cut-off and setup LED.


Изображение

По приходу аппаратуры отпишусь более углубленно.
С уважением Silenser.

_________________
T-Rex 700 Nitro
Изображение


Вернуться к началу
 Профиль  
 
Показать сообщения за:  Поле сортировки  
Начать новую тему Ответить на тему  [ 1 сообщение ] 

Часовой пояс: UTC + 2 часа


Кто сейчас на конференции

Сейчас этот форум просматривают: нет зарегистрированных пользователей и гости: 0


Вы не можете начинать темы
Вы не можете отвечать на сообщения
Вы не можете редактировать свои сообщения
Вы не можете удалять свои сообщения

Найти:
Перейти:  
cron
Powered by Forumenko © 2006–2014
Русская поддержка phpBB